Flat roofs in Dublin: felt, GRP fibreglass or EPDM

On a typical 20 m² Dublin flat extension, three-layer torch-on felt costs €1,500 to €4,000 (15–25 yrs), EPDM rubber runs €2,500 to €5,500 (30–50 yrs) and GRP fibreglass runs €2,800 to €6,000 (25–35 yrs). Workmanship at the falls, edges and wall flashings matters more than the brand name on the roll.

How torch-on felt, fibreglass and EPDM compare on Dublin extensions for cost, lifespan, winter fitting and warm-roof insulation.

Free and no obligation. Your request goes to one Dublin roofer, not a list.

  • €55–€90/m²three-layer torch-on felt
  • €70–€110/m²EPDM rubber membrane
  • €75–€120/m²GRP fibreglass laminate
  • €130–€190/m²insulated warm flat roof
Flat roof on a pebbledash Dublin rear extension with ponding water and lead wall flashing

Torch-on felt, GRP fibreglass and EPDM compared

Homeowners replacing a leaking kitchen extension, porch or garage flat roof in Dublin usually weigh three mainstream systems. Each performs reliably when laid on dry 18 mm OSB3 or exterior plywood with a clean 1 in 80 fall.

Torch-on mineral felt

Guide rate per m²
€55–€90
Typical 20 m² extension
€1,500 to €4,000
Expected lifespan
15 to 25 years
Joints and seams
Heat-welded lapped layers (3-layer SBS system)
Weather needed to fit
Dry deck; tolerant of cool Dublin days
Suits most
Value re-covers, complex shapes and roof terraces with paving pads

GRP fibreglass

Guide rate per m²
€75–€120
Typical 20 m² extension
€2,800 to €6,000
Expected lifespan
25 to 35 years
Joints and seams
Joint-free cold-applied resin shell moulded around edges
Weather needed to fit
Needs dry, mild weather (resin is sensitive to damp and cold)
Suits most
Clean architectural trims, dormers, balconies and porches

EPDM rubber membrane

Guide rate per m²
€70–€110
Typical 20 m² extension
€2,500 to €5,500
Expected lifespan
30 to 50 years
Joints and seams
Single sheet on smaller extensions; adhesive seams on big bays
Weather needed to fit
Dry deck; cold-applied with zero open flame
Suits most
Simple rectangular garages and single-storey extensions

Price your Dublin roof repair

Three taps and our Dublin guide price appears as you go. Your name and number come last, only if you want one roofer to ring you.

A flat roof repair on a semi-detached house (needed this week) in Dublin: €300 to €1,100 typical Dublin guide range.

Step 1 of 4

What is wrong with the roof?

Pick the closest match. The roofer checks the rest on site.

How the Dublin guide price is worked out

Ranges reflect typical Dublin labour and materials for each fault and house type. Small slate, tile, flat-roof and flashing repairs are normally reached by ladder or tower. Full chimney rebuilds, three-storey period terraces and whole re-roofs can add scaffolding (€1,200 to €2,500). It is a planning guide, not a firm quote: one Dublin roofer inspects the roof and confirms the written figure before any work begins.

Cold flat roof vs warm flat roof on a Dublin extension

Older Dublin flat roofs were usually built as cold roofs, with fibreglass wool stuffed between the ceiling joists beneath the timber deck. Without a clear ventilated air gap above the wool, warm kitchen steam rises into the ceiling void and condenses on the underside of the cold boards, rotting the deck from below even when the waterproof felt on top is spotless.

A warm flat roof puts a sealed vapour control layer and rigid PIR insulation continuously on top of the timber deck, right under the new felt, EPDM or GRP waterproofing (€130–€190 per m²). The structure stays warm and dry year-round, and you meet current Irish Part L thermal expectations when re-roofing a habitable room.

Four non-negotiable flat-roof details to check on your quote

  • 18 mm OSB3 tongue-and-groove or WBP plywood deck. Replace any soft or stained boards rather than laying new membrane over damp timber.
  • Minimum 150 mm upstands at walls and rooflights. Chased Code 4 lead cover flashing over every wall abutment stops rain running behind the upstand.
  • Designed fall toward the gutter. Firring strips cut to create a clear fall prevent chronic puddles.
  • Safe flame-free detailing near timber fascias. EPDM and GRP avoid blowtorches altogether; quality felt roofers use safe hot-air detailing near timber eaves.

Need a patch rather than a full strip? Read flat roof repair in Dublin.

Questions homeowners ask

Which flat roof material lasts longest in Dublin?

Single-ply EPDM rubber (30–50 years) and properly laminated GRP fibreglass (25–35 years) generally outlast mineral felt (15–25 years), provided the timber deck and edge trims are detailed correctly.

Why do some GRP fibreglass roofs crack or creak?

GRP expands slightly on hot sunny days; using plain butt-jointed boards instead of tongue-and-groove OSB3, skimping on resin catalyst ratios or fitting GRP in cold damp air causes cracking and delamination.

Is torch-on felt still a good choice for a Dublin kitchen extension?

Yes. Modern three-layer elastomeric SBS torch-on felt is far tougher than old 1980s pour-and-roll bitumen, handles complex rooflight upstands cleanly and costs less than GRP or EPDM.

Can I walk on an EPDM or GRP flat roof?

Light maintenance foot traffic is fine on all three systems. If a flat roof doubles as a balcony or gets regular foot traffic, specify heavy-duty GRP with non-slip topcoat or protective promenade tiles over felt.

Everything on this site

Edge of a pitched residential roof and eaves against an overcast sky

See your Dublin guide price before anyone rings

Three quick taps: what is wrong, what kind of house and how soon you need a roofer. When you want a written price, it goes to a single Dublin roofer.